"DEMO" shows up on layered output

Discussion forum for Tawbaware's PTAssembler software, Helmut Dersch's Panorama Tools software and any other photography related software

Moderator: spamkiller

Post Reply
Wolverine@MSU
Posts: 135
Joined: Sun Dec 18, 2005 9:33 am
Location: East Lansing, Michigan USA

"DEMO" shows up on layered output

Post by Wolverine@MSU » Tue Jun 10, 2014 6:14 am

I've been away from PTA for a while, have a registered version, and recently installed PTA 6.2. When I make a layered output file I get little white "DEMO" boxes scattered throughout the output images. They're not showing up on the intermediate files, but only on the output layered images. Any clue where they're coming from and/or how to get rid of them?

If I go back and use PTStitcher, I don't get them, only when using PTAStitcher.

maxlyons
Posts: 3649
Joined: Fri Jun 20, 2003 8:55 pm
Location: USA
Contact:

Re: "DEMO" shows up on layered output

Post by maxlyons » Tue Jun 10, 2014 10:57 am

It sounds like PTAssembler doesn't think that it is registered.

Can you check the registration status using "Help -> Purchase/Register" menu item?

Thanks,

Max

Wolverine@MSU
Posts: 135
Joined: Sun Dec 18, 2005 9:33 am
Location: East Lansing, Michigan USA

Re: "DEMO" shows up on layered output

Post by Wolverine@MSU » Tue Jun 10, 2014 12:36 pm

It says it's registered to me.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest